Dinstar MTG600 Manual de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 57
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
MTG600 User Manual
34 / 57
SIP trunk description
Trunk No
The range of number is 1~99
Trunk Name
Description the trunk
Remote Address
IP address of remote platform interfacing with this equipment.
Remote Port
Q.931 port of SIP of remote platform interfacing with this equipment, the default is
5060
Outbound Proxy
SIP proxy IP address
Outbound Proxy Port
The default proxy port is 5060.
Local Domain
Refer to SIP parameter
Support SIP-T
Not the target configuration, the parameter is always no. it is for SS7.
Get Callee from
Received the called number from request domain or To header filed
Register to Remote
Defined by IETF work group RFC3372, it is a standard used to establish remote
communication between SIP and ISUP; the default is Yes; if SIP trunk does not
support, then set it to No.
Incoming SIP
Authentication Type
There are two modes: IP address and Password. If user selects password, then
password will be filled.
IP to PSTN Calls
Restriction
IP to PSTN side of the limitation on the number of calls; the range is 0~65535, the
default is no limitation; If Yes is selected, then input limitation number of calls in the
edit box appeared.
PSTN to IP Calls
Restriction
PSTN to IP side of the limitation on the number of calls; the range is 0~65535, the
default is no limitation; If Yes is selected, then input limitation number of calls in the
edit box appeared.
IP to PSTN Time
Restriction
The default setting is disabled. If Enabled is selected, then user can edit the start
and stop time of prohibition time interval. Within this time interval, all calls from IP
to PSTN are prohibited. (Calls from PSTN to IP are not limited)
Detect Trunk Status
Detect the status of SIP trunk. If select it, the equipment will send HEARTBEAT
message to peer to make sure the link status is OK.
Enable SIP Trunk
A switch used to enable this SIP trunk or not; user can select Yes or No,
when No is selected, this SIP trunk is invalid.
2.9.3 SIP Account
Figure 2-9-4 SIP Account
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 56 57

Comentarios a estos manuales

Sin comentarios