Dinstar DWG2004 Manual de usuario descargar pdf (Pagina 28)

DWG2000C-4/8G User Manual

27 / 51

Table 4-7-3 Description of Tel to IP Routing

Figure 4-7-4 Tel to IP routing Modify

It's a default route configured in gateway. It allows any number from source port 0 send call to SIP server

with any prefix.

Tel -> IP Routing

This item uses to configure incoming call routes which can be used for

recieve the calls from the GSM.

Index

It uniquely identifies a route. Its value is assigned globally, ranging from 0 to

31.The route preferentially match the rules which the value of index is smaller

Description

It describes the route for the ease of identification. Its value is character string

Source Port

It specifies the Port or Port Group which will receive the calls from PLMN

Source Prefix

All the caller number must match the source prefix. It specifies the source

prefix allow to send call out

 Any: include anonymous, 0xxxx, 1[2-9]xxxx etc.

 0xxxx: consist of some digits such as 015,08,09

 1[3-8]6:consist of some prefix, include 136,146,156,166,176, 186

Destination Prefix

All the called number must match the destination prefix, the call prefix

indicates the connected number

 Any: include anonymous, 0xxxx, 1[2-9]xxxx etc.

 0xxxx: consist of some digits such as 015,08,09

1[3-8]6:consist of some prefix, include 136,146,156,166,176, 186

Destination

Its specifies destination Port or Port Group

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Sin comentarios

Dinstar DWG2004 Manual de usuario Pagina 28